Texas Instruments TI USB2ANY Interface Adapter HPA665

Description

Texas Instruments USB2ANY INTERFACE ADAPTER HPA665-001. Condition is Used.
The USB2ANY is a small dongle intended to allow a computer to control an electronic evaluation module
(EVM) via a USB connection. These EVMs cannot normally connect directly to the computer because of
their specialized interfaces, which are typically supported on commercial computers.
The USB2ANY is a USB 2.0 device supporting several different interfaces, including:
• 13 general purpose input/output (GPIO) (shared) lines with switchable pullup or pulldown resistors
• I2C with programmable 1.5-kΩ pullup resistors
• SPI – up to 8-MHz SCLK
• UART (300 to 230,400 Baud)
• Four analog inputs, 12-bit analog-to-digital converter (ADC)
• Two analog outputs, 8-bit digital-to-analog converter (DAC)
• Four PWM outputs
• Several other interfaces
• Switchable 3.3-V or 5-V power to DUT
The USB2ANY board can source regulated 3.3-V and 5.0-V DC power to the target device, up to a
maximum of 300 mA (combined 3.3 V and 5.0 V). The voltage outputs have built-in current sensing and
limiting circuits that protect both the EVM and the USB2ANY from overcurrent, shorts, and so forth.